Shop Project: Overhead Lumber Storage Rack


This is made from 1 x 3 and dowel scrap. The horizontal parts are secured to joists using two 3-inch screws (and washers) at each joist junction. The vertical parts are secured using 3 pocket hole screws for each part. A 1-inch dowel bridges the span with 1-2 inches overhang on each side. Drill the holes for the dowels 1 1/4-inch (centerpoint) from the end of the verticals and centered across the width. Drill a hole through each end of the dowels for a 4d nail to act as a pin.

Published in: Uncategorized on November 7, 2010 at 8:20 am  Leave a Comment  

The URI to TrackBack this entry is: https://chiefsshop.wordpress.com/2010/11/07/shop-project-overhead-lumber-storage-rack/trackback/

RSS feed for comments on this post.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

%d bloggers like this: